Subject:
|
Re: Millennium Falcon Opinion
|
Newsgroups:
|
lugnet.starwars
|
Date:
|
Wed, 24 May 2000 21:17:23 GMT
|
Viewed:
|
1268 times
|
| |
|
|
In lugnet.starwars, Sonny Sidhu writes:
> > Oh, I would much rather have seen the Ninja walls as pre-printed slopes even
> > if the set cost was slightly higher (which undoubtedly it would be). I see
> > great ADVANTAGES to this:
>
>
> What I meant was that it might be great for a Ninja set, but the utility of • those
> preprinted parts ends there. You can't use them in Space, Town (for the most
> part), or anything nautical like Hydronauts or boats. Using them would be akin • to
> using a lot of 2 2 slopes printed with computer consoles as walls in a castle!
> (Mabye not THAT bad, but still...)
But you raised an example that if instead of the wall panel, there were a bunch
of pre-printed slopes that people would complain about, and that in that case,
you would rather have one large piece which is easier to toss aside. If the
choice is between a large pre-printed sloped wall piece, and a bunch of
pre-printed 2x2x3 or 1x2x3 slopes, believe me, I would rather have the slopes,
even pre-printed. And believe me, I could probably use rock printed slopes in
almost any theme.
Frank
|
|
Message is in Reply To:
 | | Re: Millennium Falcon Opinion
|
| (...) What I meant was that it might be great for a Ninja set, but the utility of those preprinted parts ends there. You can't use them in Space, Town (for the most part), or anything nautical like Hydronauts or boats. Using them would be akin to (...) (25 years ago, 20-May-00, to lugnet.starwars)
|
88 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
