Subject:
|
Re: DAT voting page up
|
Newsgroups:
|
lugnet.cad.dev
|
Date:
|
Thu, 25 Feb 1999 16:31:30 GMT
|
Viewed:
|
3229 times
|
| |
|
|
On Wed, 24 Feb 1999 21:01:07 GMT, "Chris Dee" <chris_w_dee@hotmail.com>
wrote:
> Steve Bliss writes:
>
> > 2919.dat Electric Train Light Prism 1 x 4
> > - Appears to be missing lines where Y-arms meet center.
>
> In real life the joins between the curved surfaces are smoothed. I approximated
> this by drawing the cylinders, but missing out the junction lines you refer to.
> It is a tricky part to model accurately and has no possible use (IMHO) except
> inside its matching holder (no studs or stud holes to fit onto anything else).
> The inaccurate regions don't show when it is inside the holder.
Well, that all makes sense. What it needs is some optional lines, not
hard-lines. No biggie. Like you said, this part goes inside the other
(and as far as I know, won't attach to any other brick any other way).
> I'm happy to see a "needs work" epithet added - but that work would not be high
> on my priority list, I'm afraid.
I don't think this needs a needs work.
Steve
|
|
Message is in Reply To:
 | | Re: DAT voting page up
|
| (...) In real life the joins between the curved surfaces are smoothed. I approximated this by drawing the cylinders, but missing out the junction lines you refer to. It is a tricky part to model accurately and has no possible use (IMHO) except (...) (28 years ago, 24-Feb-99, to lugnet.cad.dev)
|
97 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
