Subject:
|
Re: DAT voting page up
|
Newsgroups:
|
lugnet.cad.dev
|
Date:
|
Fri, 26 Feb 1999 05:14:41 GMT
|
Viewed:
|
3426 times
|
| |
|
|
> The 2X2 stud corner cut-outs should be "off-set" from the studs on the top by
> 20 ldu toward the corner in each direction. This is why there is way to much
> leftover space on the edges of your cut-outs.
i have fixed that and send the fix to terry.
also i added a missing stud at the edge next to the ramp.
> On the bottom of the L-shaped pit, the long leg of the L 86 ldu wide, but only
> has two columns of studs. It is 246 ldu long, and has 12 rows of studs. The
> short leg of the L is 26 ldu wide and has two colums of studs. It is 126 ldu
> long and has 5 rows of studs.
i will fix this asap
> I would also point out that the side and top edges of this part are quite
> rounded, not sharp edges. Since this curve takes up 10 ldu of space, it
> should really be modeled. This would be a difficult fix, though.
i will not fix those
|
|
Message has 2 Replies:
 | | Re: DAT voting page up
|
| (...) Without the actual element in front of you, how can you be 100% sure that you've actually fixed the problem? (...) Have you asked yourself why you missed this in the first place? --Todd (28 years ago, 26-Feb-99, to lugnet.cad.dev)
| | | Re: DAT voting page up
|
| (...) The curved edges are an essential part of the piece, especially when viewed in LDLite or POV-Ray. Not modeling them would be like leaving the curved edges off of the Windscreens - the edges are a highly recogizable feature of the part. --Bram (...) (28 years ago, 26-Feb-99, to lugnet.cad.dev)
|
Message is in Reply To:
| | Re: DAT voting page up
|
| (...) need (...) You should measure with a ruler or with lego parts (or for detailed parts people have resorted to calipers). With a plate and a brick, you can make pretty accurate measurements based on wall thickness (4 ldu), plate thickness (8 (...) (28 years ago, 26-Feb-99, to lugnet.cad.dev)
|
97 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
