To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / 7114
7113  |  7115
Subject: 
Re: RCX Controlled Air Compressor Tester
Newsgroups: 
lugnet.robotics, lugnet.build, lugnet.robotics.rcx
Date: 
Thu, 30 Sep 1999 03:16:09 GMT
Viewed: 
1225 times
  
Ralph Hempel wrote:

The page on compressor comparisons is really informative. I'm
honoured that you felt my design was worthy of testing.

The reason I made it a two stroker was to "balance" the load
on the driving system. Michael Powell's compressor tends to
"lump" along as the pressures get high, while mine seems to
lump at twice the rate :-)

The gears were chosen over the more effective pulley because
it minimised parts and drivetrain issues. I can tell you that
arranging three 24T gears in a compact fashion WAS a bit
of a challenge, as was keeping the compressor together under
pressure.

I hope the images were clear enough to figure out how to put it
together. I had trouble figuring out how to take it apart!

Thanks again for an informative article, and keep on pumpin!

<http://www.hempeldesigngroup.com/lego/compressor>

Cheers,

Ralph Hempel - P.Eng

Hi, Ralph

Your double-acting pump is still a cool design. I like the futuristic
look. It was quite easy to build from the pictures. I had to substitute
for the tall sloped brick but otherwise I followed the images
faithfully.

Of course, I'm expecting that my tester will have to be replicated and
the results verified by others before we can pass final judgement on the
efficacy of the various compressor designs.

I'm not sure what you mean by "lumping" but if I get you right, it's not
seen in the tracings from compressors using the small pump. The speed of
pumping is fast enough. You do see the "lumping" effect in the tracings
with the designs using the large hand pump because they pump rather
slowly. But the air tank will smoothen out the "lumps". As such, an air
tank is an essential component of any air compressor set-up.

Hopefully, I've generated interest in the pursuit of the ultimate Lego
air compressor design, now there is an objective means to test them. I'm
just worried I may be indundated with requests to perform the tests :-(

PS. Oops, spoke too soon, already got one!

Cheers
--
C S Soh

http://web.singnet.com.sg/~cssoh
... where air is power



Message is in Reply To:
  RE: RCX Controlled Air Compressor Tester
 
The page on compressor comparisons is really informative. I'm honoured that you felt my design was worthy of testing. The reason I made it a two stroker was to "balance" the load on the driving system. Michael Powell's compressor tends to "lump" (...) (25 years ago, 29-Sep-99, to lugnet.robotics, lugnet.build, lugnet.robotics.rcx)

68 Messages in This Thread:























Entire Thread on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact
    

Custom Search

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR