Subject:
|
RE: New Parts
|
Newsgroups:
|
lugnet.technic
|
Date:
|
Tue, 2 Apr 2002 17:47:07 GMT
|
Reply-To:
|
<WILLIAM@HOWARD-FAMILY.FSWORLDavoidspam.CO.UK>
|
Viewed:
|
1083 times
|
| |
|
|
> A variation of the above where the "1/2 long side" is actually 3/4 long. • To
> visualise this, take a long friction pin and put it in a full width beam so
> that it projects equally. Now put a 1/2 width studless beam/liftarm either
> side of the full width beam on the friction pin. Now cut off the excess of
> the pin. What you have left is what I want.
This would come in handy, if there is room I tend to use a #3 axle and
two half bushings but it's not always possible.
And quite often unsightly, especially on digger/excavator boom arms.
William
|
|
Message is in Reply To:
 | | Re: New Parts
|
| (...) If you press a piece that fits a minifig's hand inside the 3/4 pin it becomes slightly less "wobbly". Seems to work better with other pins though. (...) This would come in handy, if there is room I tend to use a #3 axle and two half bushings (...) (23 years ago, 2-Apr-02, to lugnet.technic)
|
59 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
