Subject:
|
RE: New Parts
|
Newsgroups:
|
lugnet.technic
|
Date:
|
Thu, 4 Apr 2002 17:23:17 GMT
|
Reply-To:
|
<bram@po.cwruSTOPSPAMMERS.edu>
|
Viewed:
|
1299 times
|
| |
|
|
Erik Olson writes:
> Bram, how are you going to do the corners inside the box? Tricky, huh?
Yes, it sure is. Since the 1/16" end mill is so incredibly slow, I had
to make some design modifications to the 2x4 brick so that it could be
entirely milled using a 1/8" mill. The mods include corner radiuses and
partial tubes...but hopefully it'll still be functionally equivalent.
--Bram
Bram Lambrecht
bram@cwru.edu
www.bldesign.org
|
|
Message is in Reply To:
59 Messages in This Thread:
  
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
