Subject:
|
Re: New Parts
|
Newsgroups:
|
lugnet.technic
|
Date:
|
Tue, 2 Apr 2002 06:54:01 GMT
|
Viewed:
|
977 times
|
| |
|
|
April Fools aside and at the risk of offending purists I've started cutting
up the 32173
Technic Liftarm 2 x 7 with 2 Ball Joints
Cutting off the fake rams and the one ball joint which is off at an angle
leaves a ball joint with a two hole beam attached. When used in connection
with the axle joiner with ball housing makes an excellent and far stronger
suspension link for top and bottom wishbone arms etc.
Robin
"John Barnes" <barnes@sensors.com> wrote in message
news:Gtw0G3.GpI@lugnet.com...
> I'm sure I'm not the only one who sometimes wishes for certain parts that
> TLC don't make .... yet. So, in hopes that it might inspire some Lego • design
> engineer somewhere to go ahead and just make a few, I've decided to • maintain
> a list of such items on Brickshelf.
>
> http://www.brickshelf.com/cgi-bin/gallery.cgi?f=14604
>
> I'll add new items to it as ideas come to me. Any suggestions would be • very
> welcome.
>
> JB
|
|
Message has 1 Reply:
 | | Re: New Parts
|
| Yeah, Roboslizonicles are a great source of supply of "raw" material ;) The part you describe yields a ball with a short length of cross axle attached from the other end when you chop it up as well. With some of these highly specialised parts, I try (...) (23 years ago, 2-Apr-02, to lugnet.technic)
|
Message is in Reply To:
| | New Parts
|
| I'm sure I'm not the only one who sometimes wishes for certain parts that TLC don't make .... yet. So, in hopes that it might inspire some Lego design engineer somewhere to go ahead and just make a few, I've decided to maintain a list of such items (...) (23 years ago, 1-Apr-02, to lugnet.technic)
|
59 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
