Subject:
|
Re: New angled beam
|
Newsgroups:
|
lugnet.technic
|
Date:
|
Tue, 5 Oct 1999 09:30:44 GMT
|
Viewed:
|
895 times
|
| |
|
|
"abieler" <abielerMAPSON@netzero.net> writes:
> What other ones have you modeled but not included on your web-site?
I haven't been doing much part modeling lately, but there are a few
parts on the page
http://www.math.uio.no/~fredrigl/technic/ldraw/
The two first parts are submitted for voting, the air tank and the
"connector locking without toggle notches".
The last two will probably never be submitted (not by me, anyway)
because I don't think I'll be able to finish them off.
> I'm always interrested in Technic LDraw parts, including
> (especially?!?!) the unofficial ones!
You may want to take care when using unofficial parts, as they can
change pretty much when becoming official. For example, the part may be
rotated and transposed to a different position, which means that you'll
need to go over all your models to make the necessary adjustments.
Fredrik
--
http://www.math.uio.no/~fredrigl/technic/
|
|
Message has 1 Reply:
 | | Re: New angled beam
|
| (...) That's OK, I'll probably get BOO'ed for this, but, I don't use LDRAW itself alot, I just use the parts geometry. -Amos Bieler CAPITALS in e-mail addresses are bad... (25 years ago, 24-Oct-99, to lugnet.technic)
|
Message is in Reply To:
| | Re: New angled beam
|
| (...) I'm always interrested in Technic LDraw parts, including (especially?!?!) the unofficial ones! Amos "Junior" Bieler Spambot shield at 98.6%, Captain. (25 years ago, 5-Oct-99, to lugnet.technic)
|
50 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
