To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / 2870
2869  |  2871
Subject: 
Re: RCX 2.0 -- ideas.
Newsgroups: 
lugnet.robotics
Date: 
Fri, 15 Jan 1999 22:29:37 GMT
Original-From: 
Simon Brooke <simon@jasmine.org.^antispam^uk>
Viewed: 
1372 times
  
Peter Hesketh wrote:

In article <4.1.19990101123359.00945d30@mail.telepac.pt>, Laurentino
Martins <lau@mail.telepac.pt> writes
I personally know how good I am at destroying hardware. Is not uncommon to try
to fix something and ending up destroying it even further, specially when a
soldering iron is involved.
More that 3 sensor inputs should be accessible to everybody, not only to an
elite.

Would it be worth my while to make some 4-into-one adaptor bricks and
offer them for sale?

It would consist of an 8 x 2 peg brick (for 4 bump sensors) with a
flying lead to a 2 x 2 hole brick which would plug into a single RCX
input.

Presumably with a resistor array so as to give different analog values
depending on which sensors had been hit?

How many would people want, and how much would you pay?

*If* they discriminated between the different sensors, one or two, up to
about UKPounds 35/US $50 each (though I would prefer it if they were
less)

--
simon@jasmine.org.uk (Simon Brooke) http://www.jasmine.org.uk/~simon/

-- mens vacua in medio vacuo --
--
Did you check the web site first?: http://www.crynwr.com/lego-robotics



Message has 1 Reply:
  Re: RCX 2.0 -- ideas.
 
(...) The big cost in these things, wqould be that you need 5 of the 2*2*2/3 plates at the end of Technic leads, unless you homebrew those too. AFAIK, you can only get leads, at least as far as Service packs are concerned, for about $5-$6 (with 2 (...) (26 years ago, 22-Jan-99, to lugnet.robotics)

Message is in Reply To:
  RCX 2.0 -- ideas.
 
In article <4.1.19990101123359....lepac.pt>, Laurentino Martins <lau@mail.telepac.pt> writes (...) Would it be worth my while to make some 4-into-one adaptor bricks and offer them for sale? It would consist of an 8 x 2 peg brick (for 4 bump sensors) (...) (26 years ago, 1-Jan-99, to lugnet.robotics)

46 Messages in This Thread:























Entire Thread on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact

This Message and its Replies on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact
    

Custom Search

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR