Subject:
|
Re: fixed part: JW's parts
|
Newsgroups:
|
lugnet.cad.dev
|
Date:
|
Fri, 9 Apr 1999 23:52:22 GMT
|
Viewed:
|
1139 times
|
| |
|
|
straight roadplate
also like many of your other road plates, it's missing a fair amount of studs.
missing studs? where?
> In Ledit the walls didn't show up in any of these views. I only checked 1x=
> and .5x views
> left view 1x
> front view .5x
> right view 1x
> backview .5x
> under view 1x
> over view .5x
i do not know why this is. this is not my problem.
|
|
Message has 3 Replies:
 | | Re: fixed part: JW's parts
|
| (...) Excuse me? Not your problem? If I understand this correctly, Ryan is saying that the walls of the plate do not appear in LEdit when viewed at some angles/scales. If memory serves me correctly, LEdit is the primary modeling tool used in LDraw. (...) (26 years ago, 10-Apr-99, to lugnet.cad.dev)
|
Message is in Reply To:
| | Re: fixed part: JW's parts
|
| OK here is my judgement. (...) Very good. The lines look good even in .5x 3d view, but on the front side the green lines do not extend to the edge like on the back side. Also like many of your other road plates, it's missing a fair amount of studs. (...) (26 years ago, 9-Apr-99, to lugnet.cad.dev)
|
43 Messages in This Thread:
  
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
