Subject:
|
Re: fixed part: baseplate 32 x 32 raised with ramp
|
Newsgroups:
|
lugnet.cad.dev
|
Date:
|
Fri, 9 Apr 1999 23:53:11 GMT
|
Viewed:
|
801 times
|
| |
![Post a public reply to this message](/news/icon-reply.gif) | |
In lugnet.cad.dev, Ryan Dennett writes:
> On 4/9/99, at 4:54 AM, jonathan wilson wrote:
>
> > the only known issue is the edge curving.
> > i have no plans to do that untill someone else does the canyon plate.
>
>
> If you mean 6024 Baseplate 32x32 Canyon Plate, it has already been done.
>
> Ryan
you mean that it already has the rounded edges? where can i see that? the one i
have does not appear to have them. i cant see them.
|
|
Message has 1 Reply:
Message is in Reply To:
4 Messages in This Thread: ![fixed part: baseplate 32 x 32 raised with ramp -Jonathan Wilson (9-Apr-99 to lugnet.cad.dat)](/news/x.gif) ![](/news/46.gif) ![Re: fixed part: baseplate 32 x 32 raised with ramp -Ryan Dennett (9-Apr-99 to lugnet.cad.dev)](/news/x.gif) ![](/news/46.gif) ![You are here](/news/here.gif) ![](/news/46.gif) ![Re: fixed part: baseplate 32 x 32 raised with ramp -Ryan Dennett (10-Apr-99 to lugnet.cad.dev)](/news/x.gif)
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|