Subject:
|
Re: problem with dat groups.
|
Newsgroups:
|
lugnet.admin.general
|
Date:
|
Wed, 23 Jun 1999 13:48:24 GMT
|
Viewed:
|
719 times
|
| |
|
|
In lugnet.admin.general, Todd Lehman writes:
> In lugnet.admin.general, Todd Lehman writes:
> > In lugnet.admin.general, Jeff Stembel writes:
> > > -Every message in the subgroups shows up. Example: I open .cad, and
> > > I get messages from cad.dev, cad.dat.models, etc. It is waaay too
> > > confusing to try to figure out what is going on. When I open .cad, I
> > > want nothing *but* messages posted to .cad.
>
> OK Jeff, when you go to http://www.lugnet.com/cad/ now, there is a link on
> the far left which says:
>
> View plain (without subgroups)
>
> If you click on that, then it pops you into a compact-article display of
> messages in lugnet.cad only, like the way a real newsreader works. (And
> any messages crossposted between lugnet.cad and other groups will appear
> there too, of course.)
>
> --Todd
Thanks! I noticed it in http://www.lugnet.com/cad/dat/ also, so I assume you
put it in all relavant groups. Thanks again! :)
Jeff
P.S. When loading pages from Lugnet, it tends to "stall". It doesn't actually
say "*K (Stalled)", it says "138 bytes loaded"(1) and just sits there.
Sometimes it will continue loading after a couple seconds (usually right after
I threaten it with reloading), but a significant portion of the time I have to
click "reload". Have you ever encountered this probllem before? I'm using
Netscape Communicator version 4.5, if that helps.
1 - It always stops at 138 bytes. Is this how big the toolbar is? It always
stalls after loading it.
|
|
Message has 1 Reply:
 | | Re: problem with dat groups.
|
| (...) What kind of Internet connection are you on (what speed) and where are you located? Do you have a dynamic or static IP address? I could do a traceroute to your IP address and see what kinds of latency there is. I don't think I've seen it (...) (25 years ago, 23-Jun-99, to lugnet.admin.general)
|
Message is in Reply To:
| | Re: problem with dat groups.
|
| (...) OK Jeff, when you go to (URL) now, there is a link on the far left which says: View plain (without subgroups) If you click on that, then it pops you into a compact-article display of messages in lugnet.cad only, like the way a real newsreader (...) (25 years ago, 23-Jun-99, to lugnet.admin.general, lugnet.cad)
|
42 Messages in This Thread:
 
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
