To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.admin.generalOpen lugnet.admin.general in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Administrative / General / 1853
1852  |  1854
Subject: 
Re: problem with dat groups.
Newsgroups: 
lugnet.admin.general, lugnet.cad
Date: 
Tue, 22 Jun 1999 11:02:59 GMT
Viewed: 
1065 times
  
In lugnet.admin.general, Jonathan Wilson writes:
i have decided to switch to reading through a newsgroup, mostly because
the new interface is not as good as the old one...

Can you be more specific?  What do you not like?

--Todd



Message has 2 Replies:
  Re: problem with dat groups.
 
(...) Some problems I have with the new setup: -Every message in the subgroups shows up. Example: I open .cad, and I get messages from cad.dev, cad.dat.models, etc. It is waaay too confusing to try to figure out what is going on. When I open .cad, I (...) (25 years ago, 22-Jun-99, to lugnet.admin.general, lugnet.cad)
  Re: problem with dat groups.
 
(...) When did this happen? I just checked it because I didn't know what he was talking about. Is the threaded view gone? Colors are bad for me, but I'm colorblind, so they may be ok for others. All that gray is hard to differentiate. Light gray (...) (25 years ago, 22-Jun-99, to lugnet.admin.general, lugnet.cad)

Message is in Reply To:
  Re: problem with dat groups.
 
i have decided to switch to reading through a newsgroup, mostly because the new interface is not as good as the old one... (25 years ago, 22-Jun-99, to lugnet.admin.general, lugnet.cad)

42 Messages in This Thread:











Entire Thread on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact

This Message and its Replies on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact
    

Custom Search

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR