Subject:
|
Re: Comments on parts up for vote- Pt 2
|
Newsgroups:
|
lugnet.cad.dev
|
Date:
|
Sat, 15 Apr 2000 10:33:39 GMT
|
Viewed:
|
1339 times
|
| |
|
|
On Tue, 11 Apr 2000 22:09:44 GMT, "John VanZwieten"
<john_vanzwieten@email.msn.com> wrote:
>
> 2951.dat - Technic Bucket 10 x 8: The raised curved survaces that extend
> from the "jaws" of the bucket around the underside need type 5 lines.
Oops, I ment to enquire how to do them, but forgot:)
As my system is in a total mess at the time, I'm not able to make the
corrections, if anyone else want to, it's fine by me, otherwise it'll
have to wait until I get something running here.
Regards
John
|
|
Message is in Reply To:
 | | Comments on parts up for vote- Pt 2 [DAT]
|
| 30156.dat - Panel 4 x 6 x 6 Sloped: Needs two little edgelines: 2 24 60 72 0 56 72 0 2 24 -60 72 0 -56 72 0 4728.dat - Plant Flower 2 x 2: should have type 5 lines for the inside/underside surfaces--but it's probably not worth the work :) 2951.dat - (...) (25 years ago, 11-Apr-00, to lugnet.cad.dev)
|
73 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
