To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.generalOpen lugnet.general in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 General / 34763
34762  |  34764
Subject: 
Re: What one piece would you like to see?
Newsgroups: 
lugnet.general, lugnet.dear-lego
Date: 
Fri, 21 Dec 2001 01:47:23 GMT
Viewed: 
2023 times
  
In lugnet.general, Frank Filz writes:

I think he was meaning a peak which is 3 studs across, not 3 studs wide
(the 2x3 medium slope peak in fact exists). However, what we also need
is a 1x2 and/or 2x3 low slope peak. One way to solve the 3 across peak
is to release a series of slopes like Tyco's medium slopes which are
just the slope portion without the attached brick. This would allow
getting an odd width peak with the following construction:

Y'all are way too obsessed over this problem. Why, when faced with a
completely impossible situation like a roof peak with 3 studs to cover, I
just stand on the back of my big blue ox and clap on a nice long 1x plate
down the center line. That's right, a nice long plate. Then take some pretty
1x tiles of the same color and make lean-to walls to either side--don't snap
them on, there's a good boy. Now put one more on top. Aren't you glad you
have a 3-wide roof?



Message has 2 Replies:
  Re: What one piece would you like to see?
 
(...) I see your arguement but I still agree with Frank. We need a 1x2 and/or 2x3 low slope peak. Pleaaaaase just give us a good assortment of roof tiles! Bert Waters (23 years ago, 21-Dec-01, to lugnet.general, lugnet.dear-lego)
  Re: What one piece would you like to see?
 
(...) The original question was soliciting ideas for pieces that don't yet exist that would we like to see. Granted nearly all the pieces mentioned so far have alternative ways of accomplishing something similar. But that's besides the point in this (...) (23 years ago, 21-Dec-01, to lugnet.general, lugnet.dear-lego)

Message is in Reply To:
  Re: What one piece would you like to see?
 
(...) I think he was meaning a peak which is 3 studs across, not 3 studs wide (the 2x3 medium slope peak in fact exists). However, what we also need is a 1x2 and/or 2x3 low slope peak. One way to solve the 3 across peak is to release a series of (...) (23 years ago, 20-Dec-01, to lugnet.general, lugnet.dear-lego)

30 Messages in This Thread:













Entire Thread on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact

This Message and its Replies on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact
    

Custom Search

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR