Subject:
|
Re: Why Gary cannot go to Legoland.
|
Newsgroups:
|
lugnet.general
|
Date:
|
Sun, 13 May 2001 00:59:57 GMT
|
Viewed:
|
1558 times
|
| |
|
|
I don't have any bricks close at hand right now, so I can't be totally
sure of this, though I believe the 2nd number on the brick corresponds
with it's postion in the mold. That's usually how molds are numbered,
that way if they find a lot of 02 bricks having problems, they know
where to look in the mold to see what's going on. Or which number to
tell the computer not to fill.
Tamy
Larry Pieniazek wrote:
>
> In lugnet.general, Charles Eric McCarthy writes:
> > "Tom Stangl, VFAQman" wrote:
> > >
> > > Kevin Loch wrote:
> > > >
> > > > P.S. the two digit _number_ on some elements is the "color" id.
> > >
> > >
> > > So how do they handle 141 colors with 2 digits? Hex? Octal? ;-)
> >
> >
> > Now wait a minute. Why would they *mold* the color number?
> > Is a given mold only used for a single color?
> > I think it makes more sense to use a mold for whatever
> > color you need, instead of having to make a new mold for every color.
>
> I thought that's what they did too. I don't know for sure. I do know *this*,
> though. It is possible to have a mold that has inserts to allow different
> numbers to be molded into the parts, you select the right insert at the time
> you deploy the mold to the injector machine... raises the cost of the mold,
> though.
>
> ++Lar
|
|
Message has 1 Reply:
 | | Re: Why Gary cannot go to Legoland.
|
| (...) Yep. That corresponds with my experience as well for multipart molds. All I was saying is that one CAN have inserts that vary... I can't recall the exact example at this point but I have seen molded plastic <something or anothers> that had the (...) (24 years ago, 13-May-01, to lugnet.general)
|
Message is in Reply To:
| | Re: Why Gary cannot go to Legoland.
|
| (...) I thought that's what they did too. I don't know for sure. I do know *this*, though. It is possible to have a mold that has inserts to allow different numbers to be molded into the parts, you select the right insert at the time you deploy the (...) (24 years ago, 12-May-01, to lugnet.general)
|
55 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
