Subject:
|
Re: OMR Submission and Storage
|
Newsgroups:
|
lugnet.cad.dev.org.ldraw
|
Date:
|
Fri, 23 Jul 1999 14:18:45 GMT
|
Viewed:
|
3678 times
|
| |
|
|
Thanks Bram. I was thinking along that line, but forgot about
light.dat
That would work just fine.
Ryan
*********** REPLY SEPARATOR ***********
On 7/22/99, at 11:11 PM, Bram Lambrecht wrote:
> Ryan Dennett <dennett@agate.net> writes:
> > Just how do you center it on the hinge part of a 1x2 hinge • plate
> > (:-I I have yet to figure out how to do that, so I guess that • means
> > I've got a pea-sized brain too. :)
>
> If you mean 2429/2430, it's already centered! If you mean • 4275/4276, you
> can use the method outlined in my LDraw Tutorial, using • light.dat as a
> place-holder for the origin (0,0,0). You'll have to look at a • couple
> different views to make sure the hinge is in the right place.
> Click 'Advanced LEdit':
> http://library.advanced.org/20551/home.html
> I hope that helps!
> --Bram
>
>
> Bram Lambrecht / o o \ BramL@juno.com
> -------------------oooo-----(_)-----oooo-------------------
> WWW: http://www.chuh.org/Students/Bram-Lambrecht/
> -----------------------------------------------------------
|
|
Message is in Reply To:
 | | Re: OMR Submission and Storage
|
| (...) If you mean 2429/2430, it's already centered! If you mean 4275/4276, you can use the method outlined in my LDraw Tutorial, using light.dat as a place-holder for the origin (0,0,0). You'll have to look at a couple different views to make sure (...) (27 years ago, 23-Jul-99, to lugnet.cad.dev.org.ldraw)
|
34 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
