Subject:
|
Re: OMR Submission and Storage
|
Newsgroups:
|
lugnet.cad.dev.org.ldraw
|
Date:
|
Fri, 23 Jul 1999 03:09:21 GMT
|
Viewed:
|
1369 times
|
| |
|
|
Ryan Dennett <dennett@agate.net> writes:
> Just how do you center it on the hinge part of a 1x2 hinge plate
> (:-I I have yet to figure out how to do that, so I guess that means
> I've got a pea-sized brain too. :)
If you mean 2429/2430, it's already centered! If you mean 4275/4276, you
can use the method outlined in my LDraw Tutorial, using light.dat as a
place-holder for the origin (0,0,0). You'll have to look at a couple
different views to make sure the hinge is in the right place.
Click 'Advanced LEdit':
http://library.advanced.org/20551/home.html
I hope that helps!
--Bram
Bram Lambrecht / o o \ BramL@juno.com
-------------------oooo-----(_)-----oooo-------------------
WWW: http://www.chuh.org/Students/Bram-Lambrecht/
-----------------------------------------------------------
|
|
Message has 1 Reply:
 | | Re: OMR Submission and Storage
|
| Thanks Bram. I was thinking along that line, but forgot about light.dat That would work just fine. Ryan ***...*** REPLY SEPARATOR ***...*** (...) plate (...) means (...) 4275/4276, you (...) light.dat as a (...) couple (...) (25 years ago, 23-Jul-99, to lugnet.cad.dev.org.ldraw)
|
Message is in Reply To:
| | Re: OMR Submission and Storage
|
| (...) of rotation. (...) haven't been (...) everyone else (...) do?? (...) Just how do you center it on the hinge part of a 1x2 hinge plate (:-I I have yet to figure out how to do that, so I guess that means I've got a pea-sized brain too. :) Ryan (25 years ago, 22-Jul-99, to lugnet.cad.dev.org.ldraw)
|
34 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
