To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.org.ca.rtltorontoOpen lugnet.org.ca.rtltoronto in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Organizations / Canada / rtlToronto / 1155
1154  |  1156
Subject: 
PNLTC Module Specs, repost
Newsgroups: 
lugnet.org.ca.rtltoronto
Date: 
Fri, 1 Jun 2001 13:07:27 GMT
Viewed: 
460 times
  
In lugnet.org.ca.rtltoronto, Benjamin Medinets writes:
(Quick Note to Calum: could you repost the location for the module
specs...so I can start on my module(s)? ... Thanks in advance)

http://www.pnltc.org/Modular_Table.html

I have assembled two such modules already and will probably end up doing a
few more (probably another four)  End to end it takes about an hour to build
a module, mostly because I only have one drill/saw and need to swap bits and
sawblades in and out.  Total cost of 3 modules should be around $20, and
less if you already have the screws etc.

Calum



Message is in Reply To:
  Re: Excited
 
(...) oops...sorry, I forgot all about that...well how's that going? is it "hurry, hurry, cram, cram" ? (...) I just loved it how the entire lay-out on Train 1 was formed...from semi- organization (quasi-organization, if you will) at best to (...) (23 years ago, 1-Jun-01, to lugnet.org.ca.rtltoronto)

39 Messages in This Thread:













Entire Thread on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact
    

Custom Search

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR