Subject:
|
Re: Voting Page
|
Newsgroups:
|
lugnet.cad.dev
|
Date:
|
Mon, 10 May 1999 10:38:43 GMT
|
Viewed:
|
1640 times
|
| |
|
|
legoverse@geocities.com (Terry K) writes:
> Good point. An alternate idea would be to rotate it 90 degrees in
> the Y-plane. That would place its default position in perfect
> alignment with all the axles default positions.
But this kind of thing isn't done for other parts, is it? Take the
bushes, wheels, gear cogs and so on; they must all be rotated to fit the
axles.
> Leave it as-is?
We could just argue that the cam is essentially a pulley/wheel kind of
part, rather than a liftarm. In that case, it is already rotated
properly.
> Lay it down flat?
I feel that the cam is closely related to the parts refered to as
"liftarms" in LDraw, which includes the "halfbeams". And they are all
flat.
Of course, the rotation of a single part does not matter too much, but
we recently had a discussion about the importance of a consistent
default rotation of LDraw parts.
Fredrik
--
http://www.math.uio.no/~fredrigl/technic/
http://www.math.uio.no/~fredrigl/thailand-1999/
|
|
Message has 1 Reply:
 | | Re: Voting Page
|
| (...) cinderella, cinderella, all i ever hear is cinderella... hehehhee. just kidding... FG addressed this to me personally when i presented the part... and i agree with him that this is important (especially since i was the one who started all the (...) (27 years ago, 10-May-99, to lugnet.cad.dev)
|
Message is in Reply To:
| | Re: Voting Page
|
| (...) Good point. An alternate idea would be to rotate it 90 degrees in the Y-plane. That would place its default position in perfect alignment with all the axles default positions. What does everyone think? Leave it as-is? Lay it down flat? Rotate (...) (27 years ago, 10-May-99, to lugnet.cad.dev)
|
60 Messages in This Thread:
 
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
