Subject:
|
Re: Voting Page
|
Newsgroups:
|
lugnet.cad.dev
|
Date:
|
Sun, 9 May 1999 14:02:54 GMT
|
Viewed:
|
791 times
|
| |
|
|
legoverse@geocities.com (Terry K) writes:
> The voting page is up:
> http://hugin.ldraw.org/JJ_Memorial/voting/datvote
I'm extremely happy to see the 6575 "Technic Cam" part, but say, don't
parts like this normally lie flat in the X-Z-plane in LDraw? It makes
sense to compare this part with the "Liftarm" parts in LDraw, and they
all span the X-Z-plane.
Fredrik
|
|
Message has 1 Reply:
 | | Re: Voting Page
|
| (...) Good point. An alternate idea would be to rotate it 90 degrees in the Y-plane. That would place its default position in perfect alignment with all the axles default positions. What does everyone think? Leave it as-is? Lay it down flat? Rotate (...) (26 years ago, 10-May-99, to lugnet.cad.dev)
|
Message is in Reply To:
| | Voting Page
|
| OK, LDraw elitists, The voting page is up: (URL) are a couple of minor changes to the voting format - which may well change again. I am also considering releasing this months "fixes" separately. There are a lot of pieces that have been tinkered with (...) (26 years ago, 9-May-99, to lugnet.cad.dev)
|
60 Messages in This Thread:
 
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
