Subject:
|
Re: Voting Comments
|
Newsgroups:
|
lugnet.cad.dev
|
Date:
|
Tue, 18 May 1999 17:52:57 GMT
|
Viewed:
|
801 times
|
| |
|
|
On Tue, 18 May 1999 12:56:55 GMT, Fredrik Glöckner
<fredrik.glockner@bio.uio.no> wrote:
> blisses@worldnet.att.net (Steve Bliss) writes:
>
> > Always draw edge-lines first.
>
> Is that so? I can't remember having read that in the FAQ. I'll make
> sure to sort the edges first, now that I know of this.
I've thought about writing a function in LDAO to sort a DAT file by
line-type: first the 2 (edges) and 5 (conditionals), then the 1 (may be
edges, surfaces, or both) then the 3 (triangles) and 4 (quads).
Steve
|
|
Message has 2 Replies:
 | | Re: Voting Comments
|
| Is there already a button for this? It had odd results when I tried it long ago IIRC. -John Van Steve Bliss <blisses@worldnet.att.net> wrote in message news:3741a8a1.208175...net.com... (...) (26 years ago, 18-May-99, to lugnet.cad.dev)
| | | Re: Voting Comments
|
| Steve Bliss skrev i meddelandet <3741a8a1.20817582@l...et.com>... (...) Is that safe for transparent pieces? I toyed a little with re-sorting some parts to 'outside-in' instead of 'inside-out' to make the drawing faster (minimize overdraw), but then (...) (26 years ago, 19-May-99, to lugnet.cad.dev)
|
Message is in Reply To:
| | Re: Voting Comments
|
| (...) Is that so? I can't remember having read that in the FAQ. I'll make sure to sort the edges first, now that I know of this. Fredrik (26 years ago, 18-May-99, to lugnet.cad.dev)
|
60 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
