Subject:
|
Re: Searching for alternatives
|
Newsgroups:
|
lugnet.robotics
|
Date:
|
Sat, 3 Feb 2001 07:09:56 GMT
|
Original-From:
|
Steve Baker <sjbaker1@airmail.=stopspam=net>
|
Reply-To:
|
sjbaker1@airmail.SAYNOTOSPAMnet
|
Viewed:
|
2310 times
|
| |
|
|
Dean Husby wrote:
>
> Tim Hatch wrote:
> > (WITH the exclusion of the Agenda, which you (if you know
> > C) can program yourself, writing ASM hardware controls).
The device drivers for the CIR port are being written right now - once those
are done, you won't need assembler to drive the port. Since it's mapped onto
/dev/ttyS<something>, it's pretty likely that NQC will need nothing more than
a recompile to make it run and drive the CIR port.
> I'm waiting on buying a hand held until one of them can use NQC and upload
> programs and firmware.
I'm pretty sure the Agenda will get there first - it has hardware that should
work without problems - and since it runs Linux and you can compile programs
for it using gcc/g++, there is little reason why NQC shouldn't "just work".
--
Steve Baker HomeEmail: <sjbaker1@airmail.net>
WorkEmail: <sjbaker@link.com>
HomePage : http://web2.airmail.net/sjbaker1
Projects : http://plib.sourceforge.net
http://tuxaqfh.sourceforge.net
http://tuxkart.sourceforge.net
http://prettypoly.sourceforge.net
http://freeglut.sourceforge.net
|
|
Message has 2 Replies:
 | | Re: Searching for alternatives
|
| (...) Can you supply a URL for this Agenda device? I've been unable to locate it. Too many normal "Agenda"'s out there. Thanks Dean -- Coin-Op's For Sale!: (URL) Lego Workshop: (URL) Lego Club: (URL) (26 years ago, 3-Feb-01, to lugnet.robotics)
| | | Re: Searching for alternatives
|
| for those of you who are talking about not wanting to purchase a hand-held, you may want to do a litle research again. if you check the archives there is a thread (in this group) that has a reference to windowsCE. i have usex this and it does work, (...) (26 years ago, 5-Feb-01, to lugnet.robotics)
|
Message is in Reply To:
| | Re: Searching for alternatives
|
| (...) Right now you can use a spring board module that can is compatible with the Mindstorms IR. True it can only mimic what you can capture. But that's a start. I'm waiting on buying a hand held until one of them can use NQC and upload programs and (...) (26 years ago, 3-Feb-01, to lugnet.robotics)
|
31 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
