Subject:
|
Re: Containers
|
Newsgroups:
|
lugnet.trains, lugnet.build
|
Date:
|
Mon, 13 Mar 2000 16:53:20 GMT
|
Reply-To:
|
lpieniazek@[stopspam]novera.com
|
Viewed:
|
18 times
|
| |
|
|
IRL name and logo plates are often welded onto the rib bulges so
"appear" to stick out. However they don't actually do so due to
clearance reasons. If you're not going to be stacking your sebulba
container next to other containers and not going to be gripping it, let
the tile stick out 1/2, it's not that bad. IMHO.
--
Larry Pieniazek - lpieniazek@mercator.com - http://my.voyager.net/lar
http://www.mercator.com. Mercator, the e-business transformation company
fund Lugnet(tm): http://www.ebates.com/ ref: lar, 1/2 $$ to lugnet.
Note: this is a family forum!
|
|
Message has 1 Reply:
 | | Re: Containers
|
| (...) I may end up doing that, though I would like for the containers to be able to be stacked beside each other. Of course I haven't seen a solution yet which I have all the necessary orange parts, my solution so far comes the closest (since I (...) (25 years ago, 13-Mar-00, to lugnet.trains, lugnet.build)
|
Message is in Reply To:
| | Re: Containers
|
| (...) I think I see one thing which doesn't meet my criteria, the tile will not be flush with the surface of the wall, it will stick out 1/2 plate thickness. My solution leaves it flush with the surface of the wall. I don't mind not having an (...) (25 years ago, 13-Mar-00, to lugnet.trains, lugnet.build)
|
41 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
