Subject:
|
Re: 7171 tolerance (was: Not at all a pact with the devil... (values of TLC))
|
Newsgroups:
|
lugnet.lego.direct, lugnet.general
|
Date:
|
Wed, 24 Jan 2001 15:59:00 GMT
|
Viewed:
|
283 times
|
| |
|
|
In lugnet.lego.direct, Reinhard "Ben" Beneke writes:
> In lugnet.lego.direct, Ross Crawford writes:
> >
> > Reinhard "Ben" Beneke <r.beneke@tu-bs.de> wrote in message
> > news:G7MAJA.1Lt@lugnet.com...
> > > While Lego bricks used to have a tolerance of less than a hundreds of a
> > > millimeter, today the bricks look sometimes like this (with a 0,6 mm gap
> > > between two bricks from 7171!):
> > > http://www.brickshelf.com/cgi-bin/gallery.cgi?i=28411
> > > This quality standard of bricks is not acceptable in my eyes.
> >
> > I just checked this out, cos I hadnt seen a 7171 before. It's difficult to
> > tell conclusively from the image, but it looks to me like the studs still
> > line up fairly closely. So maybe theres a reason why they reduced the width
> > of this part? I can't think of one, but that doesn't mean there isn't
> > one....
>
> If this was the only bended or wrong sized Lego® brick, I could live with that,
> but take a look at the complete folder of this gallery: none of these bricks
> has same quality as they have had in the past. :-(
> http://www.brickshelf.com/cgi-bin/gallery.cgi?f=2880
> And these are just a few out of thousands of poor quality bricks I bought
> during the last year....
>
> Regards,
>
> Ben
I just keep looking at your IVAR shelves wondering when my Ikea is going to
get in a shipment of corner units.
junior
|
|
Message has 2 Replies:
Message is in Reply To:
47 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
