Subject:
|
Re: Adding part updates
|
Newsgroups:
|
lugnet.cad.dev.mac
|
Date:
|
Wed, 14 Jan 2004 14:24:16 GMT
|
Viewed:
|
4863 times
|
| |
|
|
In lugnet.cad.dev.mac, Erik L. Knopp wrote:
> Is there a procedure for adding part updates to the parts library on a
> Mac? Has anyone figured out a way to automate it?
>
> I've noticed that the updates have folders within folders. Am I correct
> in guessing that I want to keep the contents of the old versions of the
> inner folders as well as the the contents of those in the updates?
> (And thus, should not just copy the entire contents of an updates outer
> level folder to the library counterpart.)
Hey, that's a good question. If anyone comes up with a verified
method for adding a parts update an existing Ldraw folder on a mac,
I'd like to incorporate it into this page.
http://ldglite.sourceforge.net/osxinstall.html
It only covers a full parts install, and the section on mklist
could use some work because you'll probably want to run that after a
parts update.
Don
|
|
Message has 1 Reply:
 | | Re: Adding part updates
|
| (...) Everyone should probably take what ever I say with a grain of salt, but I can't remember Stuffit Lite or Stuffit Expander ever asking where to put the uncompressed file. It just uncompresses the zip/sit file creating the new uncompressed file (...) (23 years ago, 15-Jan-04, to lugnet.cad.dev.mac)
|
Message is in Reply To:
| | Adding part updates
|
| Is there a procedure for adding part updates to the parts library on a Mac? Has anyone figured out a way to automate it? I've noticed that the updates have folders within folders. Am I correct in guessing that I want to keep the contents of the old (...) (23 years ago, 14-Jan-04, to lugnet.cad.dev.mac)
|
24 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
