Subject:
|
Re: Adding part updates
|
Newsgroups:
|
lugnet.cad.dev.mac
|
Date:
|
Wed, 14 Jan 2004 03:28:19 GMT
|
Viewed:
|
1973 times
|
| |
|
|
In lugnet.cad.dev.mac, Erik L. Knopp wrote:
> Is there a procedure for adding part updates to the parts library on a
> Mac? Has anyone figured out a way to automate it?
>
> I've noticed that the updates have folders within folders. Am I correct
> in guessing that I want to keep the contents of the old versions of the
> inner folders as well as the the contents of those in the updates?
> (And thus, should not just copy the entire contents of an updates outer
> level folder to the library counterpart.)
I'm not sure about specifics on the Mac, but I do know that the zip versions of
the parts updates just get unzipped over the original files on a PC. When
asked, I instruct Winzip to replace all duplicate files with the version from
the zip, and this then updates the files with the newer versions. In order for
this to work properly, each update has to be unzipped in order, and the output
directory for the zip has to be the one just above the LDraw directory (since
the zip file includes ldraw in its paths).
You might make a backup of your current ldraw dir, and then just unzip over it.
This should work, and if it screws things up you can always go back.
--Travis Cobbs
|
|
Message is in Reply To:
 | | Adding part updates
|
| Is there a procedure for adding part updates to the parts library on a Mac? Has anyone figured out a way to automate it? I've noticed that the updates have folders within folders. Am I correct in guessing that I want to keep the contents of the old (...) (21 years ago, 14-Jan-04, to lugnet.cad.dev.mac)
|
24 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
