Subject:
|
Re: Building LDGLite for off-screen rendering only (Was: Parts Tracker Status)
|
Newsgroups:
|
lugnet.cad.dev
|
Date:
|
Fri, 16 May 2003 15:32:32 GMT
|
Viewed:
|
1088 times
|
| |
|
|
In lugnet.cad.dev, Jacob Sparre Andersen writes:
> I wrote:
> > Don Heyse wrote: • [...]
> > So far it works fine, but ...
>
> I should probably have written that it is on a Red Hat (mostly)
> 7.3 system with some kind of x86 processor.
I only glanced at the list of errors, but maybe this is the
problem. If you already built ldglite then you have to start
over from scratch with the new makefile. Unfortunately my
makefile skills are not the best. There's no "make clean".
So "rm *.o" manually before rebuilding.
Don
|
|
Message has 2 Replies:
 | | Re: Building LDGLite for off-screen rendering only
|
| (...) I had done that (I thought). And now I have done it again. Same result. I suppose I should admit that I cheated a little bit, and just used a symlink to the directory containing Mesa (to keep my directory structure clean). But is there any (...) (22 years ago, 16-May-03, to lugnet.cad.dev)
|
Message is in Reply To:
21 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
