Subject:
|
Re: Opinions needed for Color and Edge Values
|
Newsgroups:
|
lugnet.cad
|
Date:
|
Wed, 19 Nov 2008 19:02:52 GMT
|
Viewed:
|
8600 times
|
| |
|
|
So, you guys think that models look better with black edges?
|
|
Message has 2 Replies:
 | | Re: Opinions needed for Color and Edge Values
|
| (...) Depends on the purpose :-) For instructions, the black lines make every part very obvious, while for a nice picture of the model, the softer lines look better (although the contrast in comparison2.jpg is *too* low - you can't see the parts at (...) (16 years ago, 19-Nov-08, to lugnet.cad)
| | | Re: Opinions needed for Color and Edge Values
|
| (...) BTW, both these pictures look quite awful on my Windows CRT monitor with a gamma of 1.0. I had to copy them to my painting program and adjust the gamma correction to 2.60 before I realized that the engine in Comparison.jpg was gray/yellow, not (...) (16 years ago, 19-Nov-08, to lugnet.cad)
|
Message is in Reply To:
| | Re: Opinions needed for Color and Edge Values
|
| (...) Why don't you use #000000 as the edge color? I think that looks OK even against the default black color (LDraw color 0), while the edge lines around the black in you image above are difficult to see. --Travis (16 years ago, 19-Nov-08, to lugnet.cad, FTX)
|
50 Messages in This Thread:
  
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
