Subject:
|
Re: new 2003 sets: 8455
|
Newsgroups:
|
lugnet.technic
|
Date:
|
Thu, 6 Feb 2003 14:59:33 GMT
|
Viewed:
|
1912 times
|
| |
|
|
In lugnet.technic, Kevin Clague writes:
> <snip>
> > 1) Two pistons to tilt bucket, clearly showing, and new type of piston w/o
> > bottom 2x2, I dislike it 'cause it will be even harder to "stack" them in order
> > to make a longer piston. With any luck there is a cross axle hole instead of a
> > round one. However it looks like it's round.
>
> I found an easy solution to piston stacking:
>
> http://www.users.qwest.net/~kclague/pistons/pistons-00.html
Nice one! TJ also have one (actually two) versions:
http://www.texbrick.com/ideas/cyl/
My point was all of these solutions is impossible with the new cylinder since
it lacks the 2 x 2 "brick" in the bottom.
/Tobbe
|
|
Message has 1 Reply:
 | | Re: new 2003 sets: 8455
|
| (...) order (...) a (...) I know. Actually you said it was more difficult. I doubt it is impossible. When I get 8455 I'll have to see what I can do. I've not had a chance to work on back to back small pistons, but I will when I get to the project (...) (22 years ago, 6-Feb-03, to lugnet.technic)
|
Message is in Reply To:
54 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
