Subject:
|
Re: Questions about LPub
|
Newsgroups:
|
lugnet.cad
|
Date:
|
Sun, 29 May 2005 18:13:50 GMT
|
Viewed:
|
1424 times
|
| |
|
|
In lugnet.cad, Philippe Hurbain wrote:
> > I just updated the documentation with this:
> >
> > LPUB STEP_NUMBER PLACEMENT edge justification relative_to
> > (snip)
>
> This was not a documentation problem... in fact all my pages were multi-step,
> and LPUB STEP_NUMBER PLACEMENT doesn't seem to work in that case. I reverted a
> page to single step, and it works fine.
Philo,
In my code and the documentation I posted yesterday, STEP_NUMBER can only be
placed relative to PLI or PAGE. It currently cannot be placed relative to the
ASSEM image. Therefore you cannot do what you want.
In LPub traditional form (which is annoying), the "mistake" of using ASSEM, is
silently ignored.
I'll work on adding this if you think it is important.
>
> Philo
Kevin
|
|
Message has 1 Reply:
 | | Re: Questions about LPub
|
| (...) OK... Note that unfortunately I still don't have that updated documentation (installer problem, see (URL) In LPub traditional form (which is annoying), the "mistake" of using ASSEM, is (...) Yes, that deafening silence is annoying. After (...) (19 years ago, 30-May-05, to lugnet.cad)
|
Message is in Reply To:
| | Re: Questions about LPub
|
| (...) This was not a documentation problem... in fact all my pages were multi-step, and LPUB STEP_NUMBER PLACEMENT doesn't seem to work in that case. I reverted a page to single step, and it works fine. Philo (19 years ago, 29-May-05, to lugnet.cad)
|
37 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
