Subject:
|
Re: Questions about LPub
|
Newsgroups:
|
lugnet.cad
|
Date:
|
Sun, 29 May 2005 04:45:54 GMT
|
Viewed:
|
1334 times
|
| |
|
|
In lugnet.cad, Philippe Hurbain wrote:
> > It is good you found a workaround, but I want to fix the LPub bug.
>
> Good luck, I guess that the overall code is quite involved!
I have this fixed and it is available in LPub 2.3.0.9.
>
> The last problem remaining for me (the results I have so far are very good!) is
Great!
> the step number placement:
> > Also on layout 3, I'd like to put step numbers in bottom left corner, to avoid
> > callout hide. But the more I change the
> > 0 LPUB STEP_NUMBER PLACEMENT RIGHT BOTTOM 0 0 STEP_IMAGE
> > line the more it stays the same :-(
> Any idea?
I just updated the documentation with this:
LPUB STEP_NUMBER PLACEMENT edge justification relative_to
- The step number can be relative to the
step image using a realtive_to of PAGE, or the Part List Image using
an realtive_to of PLI.
LPUB STEP_NUMBER PLACEMENT OFFSET x y
- x and y are values from 0 to 1. If relative_to is
PAGE then x and y are multiplied by page width and height to get the
actual offset. If relative_t is PLI then x and y are
multiplied by PLI width and height to get the actual offset.
LPUB STEP_NUMBER MARGINS m
- m is the margin in pixels.
>
> Something on the documentation too:
> - I found no information on CALLOUT VERTICAL|HORIZONTAL, got this only in your
> Pedmatic instructions...
Ummm.... it is in the documentation just after LPUB CALLOUT STEP_NUMBER MARGIN.
> - CALLOUT ROW_FIRST (step ranges) is shown in an example of the documentation,
> but is not explained
The above syntax was discarded for the CALLOUT HORIZONTAL/VERTICAL
Kevin
|
|
Message has 2 Replies:
 | | Re: Questions about LPub
|
| Hi Kevin, (...) Great! (...) Kevin, I think there is something broken in your installer build process about the help file: 2.3.0.9 lpub.html is identical to the one I got with 2.3.0.8. (...) Not in the file I got here: the following item is LPUB (...) (19 years ago, 29-May-05, to lugnet.cad)
| | | Re: Questions about LPub
|
| (...) This was not a documentation problem... in fact all my pages were multi-step, and LPUB STEP_NUMBER PLACEMENT doesn't seem to work in that case. I reverted a page to single step, and it works fine. Philo (19 years ago, 29-May-05, to lugnet.cad)
|
Message is in Reply To:
| | Re: Questions about LPub
|
| (...) Good luck, I guess that the overall code is quite involved! The last problem remaining for me (the results I have so far are very good!) is the step number placement: (...) Any idea? Something on the documentation too: - I found no information (...) (19 years ago, 28-May-05, to lugnet.cad)
|
37 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
