| |
John VanZwieten wrote:
>
> So what test do you run to determine what studs get removed?
Basically it checks if a stud primitive is close to a "inverted stud"
(the cylinders under a plate for example) or to some predefined points
added by me and remove them. The original idea was to make the bricks
really connect when they get close to each other, but I never got that
far.
Leonardo
|
|
Message has 1 Reply:
 | | Re: L3PLiTE?
|
| Leonardo: (...) So in "every" part you have put a "stud-slot-point" in all the places where a stud from another part can connect with this part. So if a stud on a non-transparent part is at the stud-slot of another non-transparent part, it is (...) (25 years ago, 29-Mar-00, to lugnet.cad.ray, lugnet.cad.dev)
|
Message is in Reply To:
| | Re: L3PLiTE?
|
| Leonardo Zide <leonardo@centroin.com.br> wrote in message news:38DFDCB4.594866....com.br... (...) So what test do you run to determine what studs get removed? -John Van (25 years ago, 28-Mar-00, to lugnet.cad.ray, lugnet.cad.dev)
|
19 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
