| |
Jacob Sparre Andersen wrote:
>
> It could be a bit heavy, but mostly on the computer, and I
> think it will work correctly for all "sensible" models.
It does take some extra time to load a big file but the speed increase
later is well worth it. After doing the initial calculations, you only
need to check the studs for the bricks you move so it's very fast.
Leonardo
|
|
Message has 1 Reply:
 | | Re: L3PLiTE?
|
| Leonardo Zide wrote... (...) I assume you have manually added extra info to all parts into your pieces.bin. Is there any chance you could export that info into some META commands to be inserted into each part in the LDraw PARTS base, so LDraw (...) (25 years ago, 29-Mar-00, to lugnet.cad.ray, lugnet.cad.dev)
|
Message is in Reply To:
| | Re: L3PLiTE?
|
| Leonardo: (...) So in "every" part you have put a "stud-slot-point" in all the places where a stud from another part can connect with this part. So if a stud on a non-transparent part is at the stud-slot of another non-transparent part, it is (...) (25 years ago, 29-Mar-00, to lugnet.cad.ray, lugnet.cad.dev)
|
19 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
