Subject:
|
Re: 7-Wide BNSF & TTX Intermodal Train & Crane
|
Newsgroups:
|
lugnet.trains
|
Date:
|
Wed, 28 Jun 2006 21:45:02 GMT
|
Viewed:
|
6873 times
|
| |
|
|
In lugnet.trains, Timothy Gould wrote:
| |
--SNIP--
| |
| |
I’m not sure how many pieces are in the locomotive. It’s considerably
heavier than the standard BNSF set. 7-wides seem closer in weight to
8-wides than 6-wide, probably due to the extra weight of all the plates
used in the bases.
|
I was curious about the weight. I have a suspicion that the new
battery-powered IR motors would not be able to perform well at all with
7-wide stuff. All the more reasont to save 9V trains!
|
I think there’s more to worry about than the weight. I’ve not been able to
figure out any decent way of getting a seven wide shell over the six wide
baseplate that IR requires. I’ve tried covering it with snotted panels, tiles
and various other things but am yet to find a satisfactory arrangement. Until
someone proves otherwise I’m fairly satisfied that an IR baseplate cannot be
used properly with seven-wide.
This is the closest
to reasonable I can think of.
Tim
|
Tim,
Here is an idea I just put together. It uses many of the 1x2-2x2 Brackets.
http://www.brickshelf.com/gallery/legotrains/DesignStudy/7wide/7wide03.jpg
I guess the only downside is that you have studs running the length of the
train. Then again it does give it a nice textured look.
http://www.brickshelf.com/gallery/legotrains/DesignStudy/7wide/7wide01.jpg
http://www.brickshelf.com/gallery/legotrains/DesignStudy/7wide/7wide02.jpg
Dave
www.GPLR.org
|
|
Message has 1 Reply:
 | | Re: 7-Wide BNSF & TTX Intermodal Train & Crane
|
| (...) Hi David, I've actually tried something similar to that before but didn't like the studs. The other problem with it is that it may not work since real studs are a little taller than half a plate. The best I've come up with so far is something (...) (18 years ago, 28-Jun-06, to lugnet.trains)
|
Message is in Reply To:
| | Re: 7-Wide BNSF & TTX Intermodal Train & Crane
|
| --SNIP-- (...) I think there's more to worry about than the weight. I've not been able to figure out any decent way of getting a seven wide shell over the six wide baseplate that IR requires. I've tried covering it with snotted panels, tiles and (...) (18 years ago, 28-Jun-06, to lugnet.trains, FTX)
|
24 Messages in This Thread:
   
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
