| |
I also planned for that one special steam train of mine to be in the
Roundhouse. Only issue is that its ALOT longer then two straight tracks. In
turn, I decided to make the entry way and Bay 6 a straight-thru bay so, I can
have my Steamer parked inside if need be. The Beast extends one of the bays
about 2 1/2 times longer then the others. I realize now how big a task this is
going to be. Without a doubt this is a table on its own. Thats actually a good
thing though because it will allow me to submerge the gears and turntable
underneath and not have to raise everything. While its still no where near a
start; more layout of tracks and what the trains look like parked. At least for
the few bays I have setup. Still need to add 6 more bays.
http://www.brickshelf.com/cgi-bin/gallery.cgi?i=170954
http://www.brickshelf.com/cgi-bin/gallery.cgi?i=170955
http://www.brickshelf.com/cgi-bin/gallery.cgi?i=170957
I also did some playing around in the void areas. I think I have a much easier
solution to simulate the appearance of a solid building. In my mind I think it
will look neat too. (Only time will tell). Once I get a module bay done I will
post some more picts.
Wayne
In lugnet.org.us.lucny, Wayne Sardullo writes:
> I took some time last night to give myself some geometry lessons. The results
> are pleasing. I can be a tad more flexible because it just so happens that each
> bay is 16 wide at the start of the track that leads into the bay (16x (x)
> baseplates). I can easily make individual module bays and add little wall
> curves between the sections in the back, while the building itself has not even
> been considered it almost will make itself. (I Hope) . Well here it is, its
> gonna have 11 bays! The other nice thing is the geometry of this circle is
> nearly perfect for the spinning center of track.
>
> http://www.brickshelf.com/cgi-bin/gallery.cgi?i=170883
> http://www.brickshelf.com/cgi-bin/gallery.cgi?i=170884
> http://www.brickshelf.com/cgi-bin/gallery.cgi?i=170885
> http://www.brickshelf.com/cgi-bin/gallery.cgi?i=170886
>
> Wayne
|
|
Message has 1 Reply:
 | | Re: Advanced Design Train Roundhouse
|
| (...) ;-)) Who said it would be a one week projekt? (...) But at this point I wanted to throw in another hint: - Do you think a turntable of 32 Studs is enough for all of your engines (and the ones you might build in future? (But as long as your (...) (24 years ago, 15-May-02, to lugnet.org.us.lucny, lugnet.trains)
|
Message is in Reply To:
| | Re: Advanced Design Train Roundhouse
|
| I took some time last night to give myself some geometry lessons. The results are pleasing. I can be a tad more flexible because it just so happens that each bay is 16 wide at the start of the track that leads into the bay (16x (x) baseplates). I (...) (24 years ago, 14-May-02, to lugnet.org.us.lucny, lugnet.trains)
|
22 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
