 | | Re: New LEGO train realism?
|
|
(...) But that means you cant do any small layout by leaving away some middle sections, right? Or do you have some kind of big plates to be put under the lower modules? Are the points of giving track from one edge of a module to the next always the (...) (25 years ago, 22-Mar-00, to lugnet.trains, lugnet.trains.org)
|
| |
| | Re: New LEGO train realism?
|
|
(...) (or (...) Thanks Larry for your answer to poor foreigner without knowledge of inches.... Next question: is there already a standard for Lego train modules, accepted by most train clubs? Or is there no compability between any of them? Regards, (...) (25 years ago, 22-Mar-00, to lugnet.trains, lugnet.trains.org)
|
| |
| | More Train Thoughts - was remote control
|
|
(...) I, for one, would not mind a totally different LEGO train system. My biggest issue with the current one is that it's just too darned big to put a fairly complex layout in a normal person's house. With the number of 4-stud trucks I've been (...) (25 years ago, 22-Mar-00, to lugnet.trains)
|
| |
| | Re: Disassembly of 12V switching motor brick
|
|
(...) Hi, If you mean the 'large' gray brick used to switch the remote points from the 12V era, well, i did open one past year. I don't have it anymore, Reinhard 'Ben' Benneke has it now (the one from the ABS ... site) It's not easy to open them, (...) (25 years ago, 22-Mar-00, to lugnet.trains)
|
| |
| | Re: infrared remote control of LEGO trains using NQC and RCX
|
|
(...) Maybe. I doubt it, though. :-) US locos need their tenders attached and I think loco's we've seen posted already may have size issues, for instance Dan's Big Boy. were someone to build an Erie Triplex, that would be even bigger. On the other (...) (25 years ago, 22-Mar-00, to lugnet.robotics.rcx.nqc, lugnet.trains)
|
| |
| | Re: New LEGO train realism?
|
|
(...) 14 tables, each 40" x 65" (128 studs x 208 studs). Total layout dimensions should be 672 studs x 1040 studs. Low end will have tracks at 8 (10?) bricks above the baseplate, high end will have tracks at 20 bricks above the baseplate. Tentative (...) (25 years ago, 22-Mar-00, to lugnet.trains, lugnet.trains.org)
|
| |
| | Re: New LEGO train realism? (was:Re:infrared remote control of LEGO trains using NCQ and RCX)
|
|
(...) non (...) the 32x32 baseplate is a nominal 10 inches square... So that means that a 45 x 60 inch module is essentially 3x4 of the monster 48 stud square baseplates. (or 4.5 x 6 of the more normal sized ones) I dunno about 40 x 65 inch (...) (25 years ago, 22-Mar-00, to lugnet.trains, lugnet.trains.org)
|
| |
| | Re: infrared remote control of LEGO trains using NQC and RCX
|
|
(...) I'm in hope of getting more realistic stuff too. But I have no idea, what Lego will bring out in future. And my fear is: as known by bar code truck, cybermaster and mindstorms nothing fill fit together again.... (Maybe starting a complete new (...) (25 years ago, 22-Mar-00, to lugnet.robotics.rcx.nqc, lugnet.trains)
|
| |
| | Re: New LEGO train realism? (was:Re:infrared remote control of LEGO trains using NCQ and RCX)
|
|
(...) next (...) the (...) pics (...) soon) to (...) rolling (...) I have no idea, what Lego will bring out. But I can't imagine it will be 8 wide... (...) based on (...) level, (...) Would someone please give me the size in studs: I have no feeling (...) (25 years ago, 22-Mar-00, to lugnet.trains, lugnet.trains.org)
|
| |
| | Re: infrared remote control of LEGO trains using NQC and RCX
|
|
(...) I'm don't agree with this, because you can use it also in buildings to switch lights in /out, controlling windmills, bridges as well, and this all over the same wires, witch are in this case the track ! Of coarce, the used 'modules 'are (...) (25 years ago, 22-Mar-00, to lugnet.robotics.rcx.nqc, lugnet.trains)
|
| |
| | Re: infrared remote control of LEGO trains using NCQ and RCX
|
|
(...) <...SNIP...> I won't go into the code detail as other members have already corrected it. I just wanted to say that if your interested in my RCX Train code, it's almost ready. (Phase 1 anyway) It has a few modes of use. MS Remote control. (...) (25 years ago, 22-Mar-00, to lugnet.robotics.rcx.nqc, lugnet.trains)
|
| |
| | Re: New LEGO train realism
|
|
(...) Other than *constant* whining and harping on the subject for as long as he's been in the GMTLC... <grin> (...) Hurricane = lots of blowing air. See also my previous comments... JohnG (the quietest of the three Johns in the GMLTC!) (25 years ago, 22-Mar-00, to lugnet.trains, lugnet.trains.org)
|
| |
| | New LEGO train realism? (was:Re:infrared remote control of LEGO trains using NCQ and RCX)
|
|
(...) This sounds almost too good to be true, but it would be very fortuitous for the GMLTC because we have just voted at our last show in La Crosse (went well, pics and mpegs to follow, but not soon as I am leaving on vacation for 2 weeks soon) to (...) (25 years ago, 22-Mar-00, to lugnet.trains, lugnet.trains.org)
|
| |
| | Re: MODEL BART TRAIN
|
|
Michael Kay wrote about his BART train car... (...) That still takes you to the main page, without a link to the BART page just yet. Fortunately, he uses an easily-guessed page name, so use (URL) Regards, -Z- (URL) (25 years ago, 22-Mar-00, to lugnet.loc.us.ca.sf, lugnet.trains)
|
| |
| | Re: infrared remote control of LEGO trains using NQC and RCX
|
|
First, let me apologize for mistyping NQC as NCQ. Hey Ben! Hope those rumors are true. So if they are going to do something with remote switches and such, will it be similar to DCC or radio/infrared control? I'm guessing some form of remote control. (...) (25 years ago, 22-Mar-00, to lugnet.robotics.rcx.nqc, lugnet.trains)
|
| |
| | Re: Pictures of GFLTC at GATS Ft Myers on our stie...
|
|
(...) Here's a few pics of one of my buses: (URL) I am building vehicles, I decided to determine the width by how "big" or "massive" it has to be. Buses are typically large things that need should be much longer than a standard car. A 4-wide twenty (...) (25 years ago, 22-Mar-00, to lugnet.trains.org, lugnet.trains, lugnet.town)
|
| |
| | Re: infrared remote control of LEGO trains using NCQ and RCX
|
|
Hi Ben F.! Maybe all your work is a little needless, since there are rumors going around here in Germany, saying Lego is going to invent new more realistic trains next year, or even late this year around X-mas...... I've heared about it from a (...) (25 years ago, 22-Mar-00, to lugnet.robotics.rcx.nqc, lugnet.trains)
|
| |
| | Re: Non-Lego trains, anyone?
|
|
Sounds like monorail to me... of course I build my monorails at 6 studs! SteveB Ralph Hempel wrote in message <000001bf92a2$97975d...pro150>... (...) (25 years ago, 22-Mar-00, to lugnet.trains, lugnet.build)
|
| |
| | Re: infrared remote control of LEGO trains using NCQ and RCX
|
|
Thanks Dan. Actually, I just came up with this myself but I added a float line as follows to stop it a little more gracefully. if (__speed == 0) {Float(OUT_A);} I'm pretty pleased with the results now. Hopefully I'll be able to avoid those train (...) (25 years ago, 22-Mar-00, to lugnet.robotics.rcx.nqc, lugnet.trains)
|
| |
| | Re: infrared remote control of LEGO trains using NCQ and RCX
|
|
(...) you never check if your speed is 0 in this task - IMO, you need to add: if (__speed == 0) {Off(OUT_A)}; (I'm guessing here, since I haven't really done any NCQ myself yet. :/ Dan (25 years ago, 22-Mar-00, to lugnet.robotics.rcx.nqc, lugnet.trains)
|
