Subject:
|
Re: Lego RC set 8369
|
Newsgroups:
|
lugnet.technic
|
Date:
|
Thu, 10 Feb 2005 07:46:31 GMT
|
Viewed:
|
11027 times
|
| |
|
|
In lugnet.technic, Maico Arts wrote:
> The receiver has two connectors: one for the front axle and one for the
> rear axle. When creating a six-wheeler and one front axle and rear axle
> are connected, I don't see any option to connect the second rear axle to
> power it...
>
> (My 4-axle or 8-wheeler uses 2 complete dirtcrusher sets...)
>
> Greetings
> Maico Arts
You mean you connect one rear axle as usuall and one rear axle to the port that
steers. If so how do you steer.
|
|
Message has 1 Reply:
 | | Re: Lego RC set 8369
|
| Tommy Eriksson schreef: (...) That is axactly the point: You cannot connect a steering axle to a driven axle connector and vice versa. These connectors are not the same. As I said, there is no option to connect the second rear axle to one receiver (...) (22 years ago, 10-Feb-05, to lugnet.technic)
|
Message is in Reply To:
| | Re: Lego RC set 8369
|
| Tommy Eriksson schreef: (...) The receiver has two connectors: one for the front axle and one for the rear axle. When creating a six-wheeler and one front axle and rear axle are connected, I don't see any option to connect the second rear axle to (...) (22 years ago, 8-Feb-05, to lugnet.technic)
|
24 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
