Subject:
|
Re: Even more Wow!! for your buck!!! was Re: Woo Hoo!!!!! (part deux...)
|
Newsgroups:
|
lugnet.org.ca.rtltoronto, lugnet.trains
|
Date:
|
Tue, 3 Jun 2003 18:37:59 GMT
|
Viewed:
|
1248 times
|
| |
|
|
David Koudys wrote:
>
> Not liking that, I get home, take two straight pieces of track I have kicking
> around, cut the metal such that there is a non-conductive gap just the length of
> the two wheelsets. Then I proceed to make a double reverse loop setup in my
> living room (get pics up hopefully tomorrow).
Just so you know, if you want to accomplish the same thing without
sawing on your track, get some clear 3M tape and stick it on the inside
face of each rail. You have to put some between the tabs connecting to
the next piece of rail, too. You can adjust the length of tape
slightly.
The upside is that it's not a permanent change to your track. The
downside is that is you use cheap tape or do a shoddy job, it'll rattle
your cars around a little. Don't do this on curves, etc.
Jeff E
|
|
Message has 1 Reply:
Message is in Reply To:
27 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
