Subject:
|
Re: Proposed Assembly Line Project
|
Newsgroups:
|
lugnet.org.ca.rtltoronto
|
Date:
|
Thu, 18 Jan 2007 19:25:32 GMT
|
Viewed:
|
3155 times
|
| |
|
|
On 1/17/07, Iain Hendry wrote:
>
> Here's what I've got so far for a prototype shuttle/carrier. The assembly
> fixture/pallet would be located on top of the RCX (8x12).
Iain-
Got a picture without the RCX on top?
-Rob A>
|
|
Message has 1 Reply:
 | | Re: Proposed Assembly Line Project
|
| (...) Yupyup, here ya go! (URL) Here are all the parts you need to make one shuttle base. (URL) One assembled base, less RCX. (URL) Tomorrow night I'll finish up the proximity detection (using a light on the back/light sensor on the front). When (...) (18 years ago, 19-Jan-07, to lugnet.org.ca.rtltoronto, FTX)
|
Message is in Reply To:
| | Re: Proposed Assembly Line Project
|
| (...) Waitwaitwait, did they build you at the Honda factory? :) I don't think we should worry about the minifig (but that's moot). (...) Not a dumb question at all - to be honest I hadn't thought about it. Once the "press down" starts happening I (...) (18 years ago, 18-Jan-07, to lugnet.org.ca.rtltoronto, FTX)
|
27 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
