| |
In lugnet.org.ca.rtltoronto, Iain Hendry writes:
> Well... I mean, The top profile of the camera is <6 studs; the widest part
> of the camera is across the base and that's 6 studs exactly. So I'd say that
> as long as the sidewalls of the tunnel are 8wide compliant (ie, 10 studs of
> width), you'd be safe to begin to degrate the clearance at the top, appr. 10
> studs up, to a minimum width at the top of 6 studs. And I mean, that's an
> *absolute* minumum; with 6 studs fo clearance, I've got ~1-2 mm of clearance
> on either side; which means if there's any rockign of the car at all, my
> camera gets the ick. :) So I'd say if it's to be compliant it's going to
> have to be 8 studs at the top.
>
> I feel really guilty imposing all these rules. :-/
>
> Iain
No problem. I just need the direction, and I'll try my best to comply.
Here's the piece I was going to use for the top arch:
http://guide.lugnet.com/partsref/search.cgi?q=6108
As the picture shows, it will cut the clearance by 2 bricks height at the
edges. So, I guess I'll try raising the entire arch just to be sure.
Thanks for replying. Play well.
Tim Strutt 8^)
|
|
Message has 1 Reply:
Message is in Reply To:
24 Messages in This Thread:
  
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
