To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.off-topic.geekOpen lugnet.off-topic.geek in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Off-Topic / Geek / 1239
1238  |  1240
Subject: 
Switch from Gnome to KDE - Turbolinux 6
Newsgroups: 
lugnet.off-topic.geek
Date: 
Fri, 3 Mar 2000 21:20:00 GMT
Reply-To: 
cjc@newsguy+nospam+.com
Viewed: 
132 times
  
Just installed this on my dual celeron box and it runs like a champ,
but I'm trying to figure out how to make KDE my default X-windows
thingie.... don't like this Gnome stuff much.

Can't get Mandrake to install on this system (doesn't seem to like my
Tekram SCSI card, although it recognizes it as the same chipset as
TurboLinux and TL works fine) but I'm going to install SUSE 6.3 and
maybe even Corel as well since I have a bag o Linux distributions
laying around.

I'm doing partitions for each system (was going to do 4 gig, think it
might be better to do 2 gig since I'm going to have at least 3-4 on
here and I'm not sure they'll all be bootable otherwise).  Will I run
into any problems if I set them up like this:

4gb logical  /
(for TurboLinux)
4gb logical  /
(for SUSE)
4gb logical  /
(for Corel)

then do:

8gb logical /stuff

and have each of them mount only their own / and /stuff?

--
Tired of waiting for LEGO Direct? Bulk Parts Sales NOW!
http://www.guarded-inn.com/lego/sales/parts.html



Message has 2 Replies:
  Re: Switch from Gnome to KDE - Turbolinux 6
 
(...) [scheme snipped] Yes, you will run into problems that way. Lilo can only boot kernels in the first 1024 cylinders of a drive. (This is the BIOS's fault, not Lilo's.) On most IDE drives, that's around 500MB. I usually set up workstations like (...) (25 years ago, 3-Mar-00, to lugnet.off-topic.geek)
  Re: Switch from Gnome to KDE - Turbolinux 6
 
"Mike Stanley" wrote... (...) Mike, I went through this very excersize a week or three ago, and found that I was trying to make it much more difficult than it needed to be. After using rpm (I'm using a Red Hat 6.1 installation here) to install all (...) (25 years ago, 4-Mar-00, to lugnet.off-topic.geek)

22 Messages in This Thread:





Entire Thread on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact
    

Custom Search

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR