| |
Jonathan Wilson wrote:
> > 2552 - The lines that make up the "creases" in the indented corners are angled,
> > and they shouldn't be. I feel this is very important. There also is an extra
> > line floating around in the pit.
>
> i promise to fix the pit extra line asap.also about the corners... i can fix those
> as well. thanks for pointing out the mistake.
>
> > 606p33 - The center line is obviously a slightly thinner line drawn over the
> > dashed lines of another straight roadplate.
>
> my mistake. i thought i could make this by changing the color of the grey bits on
> the dashed roadplate to white i could make it work. my fault. i will invistigate
> the part some more.
>
> > 608p33 - There are some extra quads in the area where the crosswalk would be if
> > this piece was a normal road plate.
>
> what is the problem here? do you mean that the fact that i used lots of quads here
> instead of one is a problem? how? does it affect the use of the part?
>
> > 609p33 - The green lines have black borders, when they should be Dark Gray I
> > think.
>
> there is no 609p33.dat in the current vote... do you mean 609p01.dat? in that case
> i can fix the problem here... i can change the color easily
>
> > x610 - The gray line on the right side is too thin.
>
> will fix asap
>
> > x611 - Pattern corners aren't lined up properly, the gray lines don't touch the
> > left and right sides.
>
>
> will fix asap
>
> > x612 - Pattern corners aren't lined up properly, the gray lines don't touch the
> > left side.
>
>
> will fix asap
>
> > These two road plates have square corners even though they have the curved
> > lines:
> > x613p01
> > 609p01
>
>
> what do you mean? do you mean that the corner of the plate itself should be square
> not round???
>
> > Many of these *will* cause me to vote 'No' on the piece in question.
> >
> > Jeff
>
> i will fix all of these problems (if i can) asap
i would just like to say that i am prepared to admit that the roadplate parts
probobly were not redy for voting on but on the 32 x 32 raised with ramp the mistakes
on the corners and also the line in the pit were all honest mistakes.
|
|
Message is in Reply To:
 | | Re: Voting page for 9906
|
| (...) i promise to fix the pit extra line asap.also about the corners... i can fix those as well. thanks for pointing out the mistake. (...) my mistake. i thought i could make this by changing the color of the grey bits on the dashed roadplate to (...) (27 years ago, 3-Aug-99, to lugnet.cad.dev.org.ldraw, lugnet.cad.dev)
|
26 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
