| |
I realize many authors have been away on vacations and may have missed these
questions/comments. On some of these, I would like responses before I vote on
them (even if the response is "what are you talking about?"
2500c01: I don't think the lights are done quite right here. There's a
reference to a 4-4cone1.dat, but I don't have such a primitive. Am I missing
it? Is it a rename of 4-4con12? There's also an extra edge line in the middle
of the outer cylinder of
3004p**: I would suggest a subfile for everything except the patterned face,
esp. since you are adding so many patterns. Also, for the left and right arrow
patters you draw the black outline before the yellow arrow, but switch them for
the up/down arrow partterns. The outline doesn't show as nicely for the up/down
patterns.
3010p05: does this pattern actually have black lines around the white stripes?
If not, the white rect.dat's should be inlined and the edgelines removed. If
so, then the rect.dat's should be replace with a subfile with a white quad
surrounded by a 2D black border, not 1D edgelines.
30152: is the thickness of the frame really just 1 ldu? Generally, Lego
doesn't go less than 2 ldu in thickness.
3039p33: this could use the 3039s01.dat subpart included with this vote for the
brick minus the sloped face.
3298p66: uses color 8 edgelines in the pattern. If there is a dk. gray border
around the pink triangles, it should be done with
quads, not edgelines.
4181p06,4182p06: The colored edgelines around the patterned areas are
unnessesary, since they don't represent physical edges.
Same for 4215p04-7, unless those patterns have colored borders, in which case
they should be done in 2D, not with 1D edgelines.
4523: I, too, think this should go under the Minifig category.
-John Van
|
|
Message is in Reply To:
 | | Re: Voting page for 9906
|
| Voting part comments: 2400, 6105: The 1/2 cylinder studs on the doors need 4-4edge.dat's where they meet the flat part of the door. 2500c01: I don't think the lights are done quite right here. There's a reference to a 4-4cone1.dat, but I don't have (...) (25 years ago, 3-Aug-99, to lugnet.cad.dev.org.ldraw, lugnet.cad.dev)
|
26 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
