| |
> The button is hollowed out on the back side, and has a box thing hanging from the bottom. These need to be modeled as the switch
> should be usable in both up and down possitions.
ok. i will add a box on the bottom of the part. how bug (in ldu) whould i make it? i cant tell from looking at the part
> The box is missing a notch on the back inner side (which shows when the cover is on).
will investigate this. didn't see that one
> > except the clip. i will add the rectangular face part of the clip to the lid part if i need to but the curved bits... one of them • needs
> > a 2-4ring primitive of some kind. we do not have one.
>
> We have a couple 1-4ring primitives, and could add another if needed.
> >
> >
would the part be ok if i added the face of the clip only?also how would i measure the clip??? i only have a stanrdard milimeter
ruler...
i do not intend to buy anything special to measure parts. if i need calipers or something then forget it because those things cost more
than i am prepared to spend on this ldraw work.
|
|
Message has 1 Reply:
Message is in Reply To:
 | | Re: Voting page for 9906
|
| Jonathan Wilson <wilsonj@xoommail.com> wrote in message news:37A77C06.513643...ail.com... (...) missing The button is hollowed out on the back side, and has a box thing hanging from the bottom. These need to be modeled as the switch should be (...) (25 years ago, 4-Aug-99, to lugnet.cad.dev.org.ldraw, lugnet.cad.dev)
|
26 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
