Subject:
|
Re: New LDDesignPad Plugin
|
Newsgroups:
|
lugnet.cad
|
Date:
|
Fri, 23 Aug 2002 15:30:30 GMT
|
Viewed:
|
660 times
|
| |
|
|
In lugnet.cad, Philippe Hurbain writes:
> Really great !
> I found two very minor problems:
> - with Technic ribbed hose, if distance between enpoints is greater than
> given length, the error message is "lenght of curve longer than the distance
> between endpoints" instead of the contrary.
> - with 750/752 endpoints no check is done on this distance. If greater than
> hose length strange results happen...
>
> Do you intend to release source code for this plugin ?
>
> Once again, thanks ! I was almost ready to install Emacs ;o)
> Philo
Thanks for tips, I'll include them in the next release
-Orion
|
|
Message is in Reply To:
 | | Re: New LDDesignPad Plugin
|
| Really great ! I found two very minor problems: - with Technic ribbed hose, if distance between enpoints is greater than given length, the error message is "lenght of curve longer than the distance between endpoints" instead of the contrary. - with (...) (22 years ago, 23-Aug-02, to lugnet.cad)
|
31 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
