Subject:
|
Re: New LDDesignPad Plugin
|
Newsgroups:
|
lugnet.cad
|
Date:
|
Fri, 23 Aug 2002 09:24:53 GMT
|
Viewed:
|
626 times
|
| |
|
|
Really great !
I found two very minor problems:
- with Technic ribbed hose, if distance between enpoints is greater than
given length, the error message is "lenght of curve longer than the distance
between endpoints" instead of the contrary.
- with 750/752 endpoints no check is done on this distance. If greater than
hose length strange results happen...
Do you intend to release source code for this plugin ?
Once again, thanks ! I was almost ready to install Emacs ;o)
Philo
In lugnet.cad, Orion Pobursky writes:
> I've updated my plugin. It now handles ribbed hoses and flexible axles as
> well. I also added the various values used in curve generation at the
> bottom of the curve. It can be downloaded at the same spot:
>
> http://www.pobursky.com/Ldraw.htm
>
> As usual, all comments are welcome.
>
> -Orion
|
|
Message has 1 Reply:
Message is in Reply To:
 | | Re: New LDDesignPad Plugin
|
| I've updated my plugin. It now handles ribbed hoses and flexible axles as well. I also added the various values used in curve generation at the bottom of the curve. It can be downloaded at the same spot: (URL) usual, all comments are welcome. -Orion (22 years ago, 19-Aug-02, to lugnet.cad)
|
31 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
