Subject:
|
Re: Tinkering the 8880 suspension setup
|
Newsgroups:
|
lugnet.build
|
Date:
|
Wed, 23 Dec 1998 20:32:48 GMT
|
Viewed:
|
2611 times
|
| |
|
|
Larry... What parts are you looking for from the 8437? I only have 1 but
don't nearly all the parts.
Fred... There are 4 yellow "A" arms in the 8437.
Warning about the flex link w/the ball joints on the end. DO NOT let a 5yr
old hold a completed car w/it being used for steering, they tend to "bend"
in weird ways in the hands of a 5yr old.
|
|
Message has 2 Replies:
 | | Re: Tinkering the 8880 suspension setup
|
| (...) Well I have 2. So I have enough of the specialty steering parts, etc. What I would want would be the 1 and 2 bend round end technic beams and other construction parts. I have plenty of gears and differentials for the kind of building I do (...) (26 years ago, 24-Dec-98, to lugnet.build)
| | | Re: Tinkering the 8880 suspension setup
|
| (...) Ah, but they're not the kind which can tilt in the end opposite to the ball joint, right? The ones on the 8437 are basically a 2x1 plate with an A-arm and a ball joint? I'm sorry to say that it's probably hard to make independent front (...) (26 years ago, 24-Dec-98, to lugnet.build)
|
Message is in Reply To:
| | Re: Tinkering the 8880 suspension setup
|
| (...) Just as a note, I have enough of the gears and such from 8437, but would be willing to buy a partial 8437 from folks after they raided one for the parts they needed. MacFrugals had these at 1/2 off for a while. I got 3, sold one off and parted (...) (26 years ago, 23-Dec-98, to lugnet.build)
|
22 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
