To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.trainsOpen lugnet.trains in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Trains / 2733
2732  |  2734
Subject: 
Re: More Questions from Another Train Newbie
Newsgroups: 
lugnet.trains
Date: 
Sat, 20 Nov 1999 03:49:49 GMT
Viewed: 
2610 times
  
> 
> 1)This has to do with the fact that the regulators output voltage are slightly
> different due to tollerance of the components.
> 2)You may NEVER connect the outputs from voltage regulators to each other
> without a serie resistor and appropriate electronic cirquitry.
> If you need a higher output current,you can use an other voltage regulator
> capable for higher output currents (you need then also a heavier transformer
> too [more Amp.,at the same voltage]) .

*** Warning *** Not a Lego purist application ***

MRC Tech II throttles, well known in the model railroading world, solve this
problem nicely.  I have a passenger train with two locos (4 motors) which is no
problem at all for my MRC throttle.  I have had some of my train motors for
three years and have not burned any of them out.  A cautionary statement, MRC
throttles are 12 volt.  This has not been a problem, however.  When I first
hooked up the MRC throttle I did some test runs with a multi meter monitoring
the voltage.  I couldn't get over 6 volts without running the train off the
tracks.  MRC throttles also make it easier to pull slowly away from train
stations and coupling cars.

- Jim

---



Message has 1 Reply:
  Re: More Questions from Another Train Newbie
 
Jim Rorstrom wrote in message ... (...) slightly (...) transformer (...) this (...) is no (...) MRC (...) monitoring (...) I also saw somewhere something about a new MRC throttle which has a switch which divides output voltage by two. This switch (...) (27 years ago, 21-Nov-99, to lugnet.trains)

Message is in Reply To:
  Re: More Questions from Another Train Newbie
 
(...) This is so,but this won't mean that you can't place 3 or 4 motors on the track. The transformer gives 10V output at a 'power' of 7VA. Some explanation : VA is the multiplication of Volts & Ampere. This means in our case that the transformer (...) (27 years ago, 19-Nov-99, to lugnet.trains)

36 Messages in This Thread:












Entire Thread on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact

This Message and its Replies on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact
    

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR