| |
I don't use the RCX but I do know know to control a motor.
I would picup the power and "pulse" the motor will e.g. 400 Hz, but
pulse-wide-modulated.
The idea is that the motor gets full power but not all the time meaning thar
it has full strenght but you just adjusts the speed.
I guess you can do something like this with the RCX but I would make special
hardware for it using a Stepmotor driver or a H-bridge.
I my opinion it should not be that complicated.
Sonnich
sebarile-MOBL <steve.e.barile@intel.com> wrote in message
news:GDJtwy.Dp5@lugnet.com...
> Since you guys are talking about this I have a question. I've asked it
> before and there was no responce. Here it goes:
>
> I want to use the RCX to control a single train thru the rails by • providing
> "pulsed" voltage to have fine control over the trains speed. Any solutions
> out there?
>
> SteveB
> PNLTC
|
|
Message has 1 Reply:
Message is in Reply To:
 | | RCX motor pulsing
|
| Since you guys are talking about this I have a question. I've asked it before and there was no responce. Here it goes: I want to use the RCX to control a single train thru the rails by providing "pulsed" voltage to have fine control over the trains (...) (24 years ago, 18-May-01, to lugnet.trains, lugnet.robotics)
|
25 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
